CHA/IK/TR/A 18÷35 + DMS220
A CLASS ENERGY EFFICIENCY AIRCOOLED REVERSIBLE HEAT PUMPS WITH EC INVERTER AXIAL FANS, INVERTER ROTARY COMPRESSOR, PLATE EXCHANGER, HYDRONIC KIT AND DISTRIBUTION MODULE FOR DOMESTIC HOT WATER PRODUCTION.
Thermica System is a fully hydronic system for room heating/cooling and domestic hot water production up to 55°C.
The system consists of a monoblock air/water heat pump with built-in hydronic module and an indoor unit with 220 l tank, hydraulically connected to each other. It is ideal for floor heating, medium and low temperature radiators, fan coil units and domestic hot water production, in new housing or in buildings with low energy demand.
The stylish version, finished in every detail, can be installed on sight and, thanks to its current design, it lends itself to any type of location.
Through the easy-to-use Touch Screen user interface, it is possible to control the operating parameters of the Heat Pump, as well as of the entire system.
The units are compliant to the ErP Regulation.
The interior distribution module contains all hydraulic and electric components to facilitate installation and maintenance procedures, which thus become very simple.
- CHA/IK/TR/A+DMS220 - Reversible Heat Pump and Distribution Module Stylish version
- Self-supporting galvanized steel frame protected with additional protection achieved via polyester powder painting.
- DC INVERTER Rotary compressor, with DC BRUSHLESS motor, complete with overload protection.
- EC INVERTER axial fans with low ventilation and special wing profile, directly coupled to external rotor motors.
- Condenser with copper tube and aluminium finned coil, complete with drain pan and protection guards.
- Evaporator plate-type AISI 316 stainless steel, equipped with antifreeze heater.
- Electronic expansion valve.
- R410A refrigerant.
- Electrical board includes: main switch with door lock device, fuses, compressor and pump remote control switch.
- Electronic proportional device to decrease the sound level, with a continuous regulation of the fan speed. This device also allows the cooling functioning of the unit by external temperature till -20 °C.
- Functioning in heating mode with outside air temperature down to -20 °C.
- Water circuit includes: circulator with high efficiency DC BRUSHLESS motor, flow switch, safety valve, gauge and expansion vessel.
- Distribution module for domestic hot water production complete with 220 l DHW tank, 3 kW supplementary electric heater predisposition, 3-way DHW/system diverter valve, non-return valve, hydraulic separator, medium temperature zone flow rate calibration valve, pressure gauge, expansion vessel, pump and mixing valve for low temperature zone, automatic air vent valve, safety valve and water drain, domestic hot water flow switch, thermostatic domestic hot water mixer.
- Microprocessor control and regulation system.